How To Attach Cord To Garage Door Bottom

Use impact driver to mount hinges to the bottom panel of garage door.

How to attach cord to garage door bottom.

The cables wrap around the drums as the door opens and unwind from the drums when closing. If your garage door cable is at an angle or l. Now attach the cable to the bottom bracket. Rotate the drum to wind the cable into the winding grooves.

Leave the locking pliers in place and repeat the tightening procedure on the other side. Clamp it into place. Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums. Attach weather stripping to the bottom edge of garage door.

Remove the cable from the bottom bracket and then completely remove the cable from the door. Install the roller into the bottom bracket and thread the cables behind the rollers on the door. Push the track into wet caulk and tight against the door bottom. Diy garage door repair and save money.

Then drill and screw the track to the back of the door using 1 in. This video will show you how to repair a mis aligned garage door cable. With the cable behind the roller and bracket install the bottom bracket on the garage door. Pull the cable as tight as possible before tightening the setscrews.

Fasten a new garage door bottom seal to a wood garage door. Insert rollers into the brackets attached to the door. Always be careful when using a sharp knife. The cables attach at the bottom end to the bottom bracket that is mounted to the bottom of the bottom panel.